3-way tipper body for 2A truck – building site

• Product details

  TYPE DESIGNATION

  3-WAY TIPPER BODY ON 2-AXLE TRUCK – BUILDING SITE
  For handling bulk materials such as sand, gravel, rubble, ground excavation etc. on building sites

  WEIGHTS

  Body weight: approx. 1.7 t

  DIMENSIONS

  Internal length: approx. 4,500 mm
  Internal width: approx. 2,420 mm
  Load volume: approx. 7.5 m³
  Total width: 2,550 mm

  Body height, loading height etc. can only be checked and announced upon specification of the
  exact truck data

  PAINTWORK

  Blasted with steel granulate, treated with zinc dust primer and spray painted
  2-component acrylic paints for commercial vehicles (standard RAL or truck colour)

  Plastic and hot-dip galvanised parts unpainted,
  powder-coated attachments black

  Reflective contour marking strips across entire length of sides (continuing onto truck cab) and all-round contour marking at rear (white on sides and red at rear by default), according to ECE 48

  ACCESSORIES

  Rear markings as per ECE standards

  ATTACHMENTS

  Tipper body rubber centre support
  Bracket for wheel chock(s)
  Mud flaps for rear mudguards
  Shovel and brush brackets
  Rubber skirting on side walls on both sides
  Rubber bump stops on end plate
  Hooks for dosing chains on swivelling rear wall

  SIDE WALLS

  Fixed steel plate front wall, 3 mm, approx. 980 mm high

  1-part reinforced aluminium hollow profile side walls, 60/4/3 mm, approx. 680 mm high,
  foldable with extended swivel bolt locks and spring lifting aid,
  hinged with man. central locking
  Aluminium hollow profile rear wall, 60/4/3 mm, approx. 780 mm high,
  hinged with raised bearing and pneum. locking opened from cab,
  foldable with extended swivel bolt locks

  Fixed rear corner posts, raised, side-mounted

  SUBFRAME

  Continuous side members with tilt cylinder bearings and outriggers
  Body height above chassis: approx. 400 mm
  Connector lock for tipper body with cross-over protection

  HIGH-PRESSURE HYDRAULIC TIPPING SYSTEM

  16 t tilt cylinder for 3-way tipping, with safety rope,
  40 l pump for direct flange mounting, 35 l oil reservoir with oil filling,
  pneum. tip valve with overpressure protection and actuation in cab

  TIPPING LOADING RAMP

  Full-steel welded construction with fine-grained special steel floor panels, 5 mm
  HARDOX HB450
  (slight floor unevenness possible due to weld distortion)