3-axle low-loader trailer with straight platform

• Product details

  TYPE DESIGNATION

  CENTRE-AXLE LOW LOADER TRAILER – TYPE TÜP

  WEIGHTS

  Gross weight: 20 t
  Tare weight: approx. 4. 6 t

  FRAME

  Centre-axle welded steel construction = contracted before bridge platform,
  with bolted drawbar eye 50 mm ( drawbar eye DIN 50 ), suitable for
  truck superstructure up to 500 mm and unladen coupling height of 950 mm,
  without front frame offset or body offset and drive-on taper at rear
  with externally welded square ribs

  4 pairs of lashing points under external frame
  2 pairs of recessed lashing rings in floor

  CHASSIS

  Air suspension with lifting and lowering device (for loading and unloading)
  Automatic adjustment of driving level from 15 km/h

  Air-sprung low-loader unit with low-maintenance axles,
  each with 11 t axle load
  S-cam brake 300/200 mm, autom. brake linkage adjuster

  Tyres:
  8 x 2 4 5/7 0 R 17.5 14 3 J, manufacturer as per factory specifications
  8 steel wheel rims 6.75 x 17.5, 10-hole, with rim offset, silver ex-works

  SUPPORT FIXTURES

  1 mech. support jack with hand crank at front
  2 foldable support legs at rear

  BRAKE SYSTEM

  Two-line brake
  Spring-loaded parking brake
  EBS – electronic brake system (Wabco 2S2M)
  RSS – stability program
  Steel air tank

  FLOOR

  Softwood floor 50 mm, waterproofed, protruding approx. 5 – 10 mm beyond frame
  profiles or beyond steel stud plate cover over rear wheels

  RAMPS

  2 foldable, 1-part loading ramps, approx. 2,850/700 mm, with hardwood flooring
  with externally welded square ribs
  Ramp width adjustable (with rod),
  lockable in driving position using chains with turnbuckle
  Lifting aid with coil spring

  ELECTRICAL EQUIPMENT

  Fully compliant with motor vehicle regulations – 24 V
  2 five-chamber tail lights
  Side marker lights
  Fixed cable(s) with 2 x 7-pin or 1 x 15-pin connector

  PAINTWORK

  Blasted with steel granulate, treated with zinc dust primer and spray painted
  2-component acrylic paints for commercial vehicles

  Reflective contour marking strips across entire length of sides and on the rear (white on sides and red at rear by default), according to ECE 48

  ACCESSORIES

  Rear markings as per ECE standards

  ATTACHMENTS

  Side impact protection
  Wheel chock(s) as per regulations
  Plastic mudguards or splashguards with spray protection as per regulations
  Spare wheel well for 1 spare wheel

  BRIDGE PLATFORM

  Approx. 5,000/2,550 mm = flat load surface
  Approx. 1,000/2,550 mm = rear access slope
  Total width: approx. 2,550 mm
  Loading height, laden: approx. 920 mm